Three devices. A speakerphone, a voice-assistant hub and a handheld virtual pet. Claude Fable 5.2 designed them from schematic to firmware, and Diode Computers assembled the boards under its direction.
Fact
The facts: on 9 November 2026 Anthropic announced that Claude can now design and prototype electronic hardware from start to finish. In a collaboration with Diode Computers, the company asked Claude Fable 5.2 to design three devices: a speakerphone, a voice-assistant hub and a handheld virtual pet. According to Anthropic, the model modelled the circuits, anticipated manufacturing constraints, revised its own work, modelled its designs in CAD software and finally directed human engineers to build prototypes that worked without any fixes to their circuitry. The prompt for the speakerphone asked for a puck that plugs into a computer over USB-C and includes microphones and a speaker, supporting Bluetooth with a PCB antenna. According to Anthropic, the speakerphone prototype still works after weeks of use. On Diode's internal PCB Gym benchmark, Fable 5.2 scores 69% against 25% for Fable 5. On the public BenchCAD 2.1, Fable 5.2 scores 83.5%, nearly double its predecessor Claude Fable 5.1. Anthropic says the devices are early prototypes and it does not yet know how they will hold up with continued use or whether they would pass commercial certifications.
The biggest difference is in the geometry. Earlier models placed supporting parts too far from the chips they served, or oriented connectors incorrectly. Fable 5.2 lays things out more compactly and starts with the connections that matter: the high-speed ones and the high-current ones.
For the hub with long tracks running from a 100-pin connector, Claude judged that routing them one by one would take too much step-by-step guidance. It wrote its own tool: it divides the board into a grid and searches for a clear path for each track. Within about half an hour it had a router that could lay each long track in roughly a second.
And it goes back. When it saw the copper connections getting too tangled to trace visually, it decided to rip them and start fresh. It deleted and rerouted connections dozens of times until it found an arrangement that worked.
It also read the charger's datasheet. Asked whether the handheld pet would work without a battery, it answered that it would run on USB power but predicted the charging light would flicker, because the charger keeps recharging a small capacitor in the battery's place.
On stage I have seen a prototype that works on the table and dies in front of an audience. The difference is how many times someone ran it before showing it.
According to Anthropic the prototypes work with no fixes to their circuitry, but they are early builds and it is not known whether they would pass commercial certification.
Anthropic says it itself: the devices are early prototypes. It is not known how they will hold up with continued use or whether they would pass commercial certification. The PCB Gym and BenchCAD 2.1 numbers are its own too. There is no independent evaluator on the page.
If you build hardware, read these numbers as the start of a conversation, not a verdict. They are Anthropic's, and the devices are still prototypes.
Official primary sources
Anthropic - Claude can design electronic prototypes from start to finish, 09.11.2026The visual is generated code-art, no third-party images.